How Do I Make A Roof Rake

I have to say it worked great i used the metal part face down not the rubber part.

How do i make a roof rake.

Use your clamp to attach the two 4 inch brackets to one end of the aluminum pole positioning one angled bracket on each side. An added bonus was that i could use one end of. Use the drill to make a hole in the aluminum pole using the bracket holes as a guide. Drill straight through the aluminum handle through one bracket hole to the hole on the other side using your.

When the snow started to pile up on handyman bill. Apply some pvc glue to the inside of the arms. The roof rake plates are installed in different widths depending on the surface being covered. Without a real roof rake i was forced into searching the garage to craft something homemade.

Insert your 2 1 2 inch. Measure and place a mark 2 from an end. How to make a roof rake step 1. Begin by cutting two 12 sections from one on the 1 x 10 pvc pipes.

Position a bracket on each side of the. Make sure the holes on the brackets are lined up and are angled at 90 degrees. Rake plates of one by 2 inches often cover the exposed top edge of the liner when there is also a ledge at the end of the gable. Make this easy avalanche roof rake for the winter and let a clever diy design do all the work for you.

On the 1 x 12 arms where you placed the marks in the previous step use the hole saw to bore straight through. Attach the two 4 inch angle brackets to the end of your aluminum pole.