You don t need to get a professional in to apply rolled roofing to your house or shed you can do it yourself.
How do you attach roll roofing.
Just be sure that the side edge of this roll is overlapped by at least 6 inches of the side edge of the next roll and that you seal the seam between the two with cement.
Attach he ridge cap shingles with two nails each.
If you find that you run out of roll before you make it across the entire length of the roof during one of the courses this is not a problem.
However roll roofing does not look nearly as good as shingle or tile so it is typically only used on roofs that are not readily visible.
If the roof is sloped you can use the exposed nail method.
How to install a roof over an existing roof.
It can be installed simply and requires only nails and roofing cement.
If you are wonder how to install roll roofing the following information may be useful for you.
If you get the right materials and stick.
Trim the shingles away from the ridge vent hole.
It is a great option for flat or nearly flat roofs since they aren t visible from the ground and is a project that you can do in a day.
Installing a new roof over an existing one also called a layover or nailover is often possible although not always the best option.
It has a life expectancy of anywhere from six to 10 years but it s fairly inexpensive.
When compared to shingles rolled roofing is far cheaper and much easier to apply.
Roll roofing is a lightweight roofing material that s sold in a large roll.
Rolled roofing materials differ according to their base material binder material and a fraction of spreading.
Nail the roofing in place with short roofing nails spaced 6 inches apart and 1 inch in from the outer edges of the roll roofing.
Rolled roofing has become more and more popular in recent years.
Adhere the joint where the cut edges of the shingles meet the dome with roofing tar.
As the basis of these materials fiberglass and polyester are often used.
For a slightly sloped roof use the concealed nail method shown.
Attach the plastic ridge vent with 3 roofing nails.
If the plumbing vent is close to the peak of the roof lap the shingles over the peak of the roof.
Add a second piece of full width roll roofing over the first.
