Multiply height by width for each area and add to get total soffit square footage needed.
How many nails per piece of vinyl siding.
These grip rite 1 1 2 in.
Center nails in slots.
Aluminum siding nails 1 these grip rite 1 1 2 in.
If your siding sounds like rodents running inside the walls whenever the sun shines on it you may have one or more pieces that were nailed too tightly.
All fasteners must be able to penetrate a minimum of 1 1 4 32mm into nailable material such as wood sheathing and framing fig.
1 140 nails per 1 000 lineal feet.
X 10 siding.
Space nails a maximum of 16 inches apart for horizontal siding panels every 12 inches for vertical siding panels and 6 to 12 inches for accessories.
Aluminum siding nails 1 lb pack feature a large head and thin smooth shank that helps to reduce wood splitting.
You will need about 2 3 of a pound of nails per square of siding being installed.
Vinyl siding is installed by nailing it to the building.
They are good for installing aluminum or vinyl siding.
Take length and width measurements in the area underneath your eaves.
Total of squares please enter side s surface area.
Drive nails straight and level.
1 520 nails per 1 000 lineal feet.
This will permit expansion and contraction as well as prevent dimpling which causes waves in siding.
Vinyl siding tends to expand and contract considerably with temperature changes.
2 280 nails per 1 000 lineal feet.
X 8 siding.
Multiply the run of 16 by the rise per foot or 42.
The bottom edge of a siding or soffit panel or accessory piece opposite the nailing slots which locks.
Between nail head and vinyl.
Use aluminum galvanized steel or other corrosion resistant nails staples or screws when installing vinyl siding.
Do not nail to the extreme right or left of nail slot in siding panel.
X 6 siding.
Allow approximately 1 16 in.
16 x 42 6 72.
A nail should be placed about every 12 inches following the manufacturer s instructions of course.
Be sure to use a galvanized vinyl siding rated nail to prevent rusting.
See individual manufacturer s instructions for fastening specific accessories and for recommended spacing make sure the panels are locked at the bottom but do not pull them tight when nailing.
